Consist of production line:
A: Passive Decoiler |
B: Feeding Applicator |
C: Roll Forming machine |
D: Hydraulic Cutting |
E: Output Table |
Detailed specification of each part:
A.Passive decoiler
Max. width of coil can be loaded | 200mm |
Mandrel face length | 400mm |
Max. weight of coil can be loaded | 3 tons |
Iner-diameter | 480-530 mm |
Max.Out diameter | 1400mm |
Material of shaft | GCr 45 steel |
Diameter of shaft | 85 mm |
Length accuracy in close loop system | +/- 0.5 mm |
Surface rust-proof treatment | decorative chromed or black coating |
Feeding panel to the guide roller | Adjustable by right and left |
Feeding roller | Diameter is 55mm |
Material | #45 steel, hard chormed.HRC48-52 |
C.Roll forming machine
No. of Work Station | 14-16 sets |
Max. Roll shafts Dia | 55 mm |
Required Motor Capacity | 5.5 K.W |
Max. Line Speed | 20mtr./min(Not including cutting) |
Transducer | Yaskawa |
Roller material | GCr15 steel ,hard chromed |
Transmission | Chain driving |
Bearing | HRB |
Cages | Use the strong steel nets |
Leveling screws on base | With thick metal plates |
D.Hydraulic cutting
Hydraulic pressure | 20Mpa |
Hydraulic power | 3.0K.W |
Cutting material | Cr12,quenched 58-62 |
Cutting system | Hydraulic Die cutting |
E.Output table
Specification(L*H) | 3500mm*800mm |
Tube welded with rollers. | 1 output table |
Stacking length | According to your demands |
Consist of production line:
A: Passive Decoiler |
B: Feeding Applicator |
C: Roll Forming machine |
D: Hydraulic Cutting |
E: Output Table |
Detailed specification of each part:
A.Passive decoiler
Max. width of coil can be loaded | 200mm |
Mandrel face length | 400mm |
Max. weight of coil can be loaded | 3 tons |
Iner-diameter | 480-530 mm |
Max.Out diameter | 1400mm |
Material of shaft | GCr 45 steel |
Diameter of shaft | 85 mm |
Length accuracy in close loop system | +/- 0.5 mm |
Surface rust-proof treatment | decorative chromed or black coating |
Feeding panel to the guide roller | Adjustable by right and left |
Feeding roller | Diameter is 55mm |
Material | #45 steel, hard chormed.HRC48-52 |
C.Roll forming machine
No. of Work Station | 14-16 sets |
Max. Roll shafts Dia | 55 mm |
Required Motor Capacity | 5.5 K.W |
Max. Line Speed | 20mtr./min(Not including cutting) |
Transducer | Yaskawa |
Roller material | GCr15 steel ,hard chromed |
Transmission | Chain driving |
Bearing | HRB |
Cages | Use the strong steel nets |
Leveling screws on base | With thick metal plates |
D.Hydraulic cutting
Hydraulic pressure | 20Mpa |
Hydraulic power | 3.0K.W |
Cutting material | Cr12,quenched 58-62 |
Cutting system | Hydraulic Die cutting |
E.Output table
Specification(L*H) | 3500mm*800mm |
Tube welded with rollers. | 1 output table |
Stacking length | According to your demands |
content is empty!